Xbloc® Moulds by BAM Materieel
BAM Materieel supplies the largest contractor of the Netherlands with building equipment and all kinds of formwork. Since the start of the Xbloc®, they prepared multiple moulds and mould designs for Xbloc® Client's and for Xbloc® development. Years of experience has led to an optimised mould design .
Advantages of Mould production by BAM Materieel
- High Quality of Moulds
- Easy and fast production of Xblocs
- High standard of service
- Design of moulds adapted to production circumstances
- Moulds are practical through years of experience
Production and transport
BAM Materieel provides a custom made mould design to the convenience on site. The moulds will be produced at the BAM Materieel factory in the Netherlands. The moulds can be transported to any location worldwide, where on site they are assembled.
Projects
- Eco Xbloc IJmuiden, mould design and fabrication
- Port Oriel, Ireland mould design
- Caladh Mor, Ireland mould design
- Port of Poti, design and fabrication of 30 moulds
- Champerico, design and fabrication of 20 moulds.
Xbloc® Mould options
The two mould halves (vertical casting method) can be split with the use of rails or wheels. In Port of Poti, Georgia quick production rates were achieved with moulds on wheels. After casting parts can be turned and used again without having to lift the hardening Xbloc® as the mould halves are symmetrical. At this location 5,000 Xbloc®s were produced in 7 months time.
For the production of ecologically adapted Xblocs the inner surfaces of the mould can be covered with structured material (for example: NOEplast), to allow different gradings of roughness, depending on the ecological demands.
You can contact BAM Materieel at the following address:
De Serpeling 120
8219 PZ Lelystad
P.O. Box 189
8200 AD Lelystad
The Netherlands
T +31 488487878
F +31 488487879
